UV DTF sticker paper (Waste Stripping Transfer Sticker material) on xTool O1 Omni Printer
videoSurface prep
Peel the clear film first; scan the bed
Layer order
White>CMYK>Gloss
White layers
3
CMYK layers
1
Varnish
6 gloss layers
Print mode
Flat; no sticker mode, set Material to Waste Stripping Transfer Sticker and build a custom Ink Mode stack
Durability
White gives the sticker its rigidity; 3W+1C with no varnish works but is a little floppy, try 4 white
Notes
Creator's final setting; enamel-pin look; full sheet took 39 min vs 9 min at 3W+1C; 10 gloss layers came out rough; run through a laminator
Source: Ashlee Falco · 2026-09-18